Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
UpdateCost Function at Work Order Receive/Close?
12-05-2018, 10:50 PM,
#1
UpdateCost Function at Work Order Receive/Close?
If we receive materials into a Work Order and the value of the parent part (i.e., WO Item) changes should we be calling the UpdateCost() function for the parent part? What if the parent part is a child part within a BoM (or BoMs) for other part(s)?

I do see where we update inventory value when this occurs so I know this aspect is covered.

Perhaps this is already covered but I wanted to ask...
https://www.linkedin.com/in/eclipsepaulbecker
Reply
12-05-2018, 10:55 PM,
#2
RE: UpdateCost Function at Work Order Receive/Close?
UpdateCost() should roll the costing up to all parents. At least it did but I know some changes were done
Reply
12-05-2018, 11:08 PM, (This post was last modified: 12-05-2018, 11:28 PM by VortecCPI.)
#3
RE: UpdateCost Function at Work Order Receive/Close?
So here is what I see. BoM cost for parent:

   

Create WO for child and receive. BoM cost for parent increases:

   

But... Material cost at parent did not increase:

   
So this is an overhead issue again. The coil has overhead cost and the parent cost rollup rollup only accounts for material cost.
So if a BoM consists of M parts and the M parts have Labour and/or Overhead should not all this roll up to the parent part?
Or... I guess we are using Labour and/or Overhead as BoM items to make this work, right?
This is why I am losing $1.50:

   

It is on overhead where I guess it should be a BoM item.
https://www.linkedin.com/in/eclipsepaulbecker
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)